Fire Protection of M&E Services Enclosures

ADVANTAGES

Electrical Cables Coating

Mechanical and electrical (M&E) services require fire protection is require to maintain function of certain essential electrical and/or mechanical systems and services, and also to prevent fire, smoke and toxic fume propagation from one building compartment to another.

It is necessary to ensure the continued function of essential electrical systems and services is maintained during fire, for a specified period of time, until all the building occupants have escaped. Electrical systems that need protection from fire may include:

  • Electrically operated fire alarms
  • Emergency escape route lighting
  • Electrically operated extinguishing systems
  • Smoke extraction venting systems
  • Power supply for fire service elevators in high-rise buildings
  • Water mains supply and pumps servicing sprinkler systems
  • Essential life support and/or computer, communication or information technology networks

In general coatings to cables are designed to restrict the spread of flame along the cables and thus reduce propagation of fire. Thin film coatings will maintain circuit integrity to small diametrical cables in restricted applications. The specifier must use with caution when recommending cable coatings to ensure the performance criteria clearly matches their expectations and requirements. If there is any doubt regarding performance and the maintenance of the circuit integrity is imperative, the specifier should consider the use of a board cladding system. For further clarification and assistance, please consult Promat.

  FRL
PROMASTOP® CIS Electrical Cables Coating External fire for circuit integrity

Note: FRL */*/* (Fire Resistance Limit – *Stability / *Integrity / *Insulation)

In the event of an internal or external fire performance, it has been established that an enclosure fabricated from fire resistant boards is one of the best solutions. Such systems have been tested successfully with encasement constructed from fire protective boards such as PROMATECT®-H, PROMATECT®-L, PROMATECT®-L500, PROMATECT® 50 or PROMATECT®-S. These well established board systems are representative of the few systems which currently fulfil all performance requirements, especially to the DIN 4102 standards.

A suitably designed duct will:

  • Prevent the propagation of fire from one building compartment to another
  • Assist in maintaining smoke free escape routes
  • Ensure the continuing operation of other services within a common service shaft
  • Reduce damage to a localised area
  • Contain smoke and toxic fumes from burning cables
  • Where required, ensure cable maintain their function when exposed to a fully developed fire

The following are some of the factors to consider when determining the correct specification to ensure the enclosure system provides the required fire performance. Please consult Promat.

Application & Technical Manual

Promat Asia Pacific Handbook

  • Application & Technical Manual 06 Mechanical & Electrical (M&E) #DownloadLabel#