Stainless steel 22.5mm with a
22mm leg

Concrete or blockwork

CAFCO® Mesh Retaining Anchor is easily installed by placing the anchor in a drilled or pre-cast 8mm hole of a minimum depth of 24mm and using a 4mm setting pin.
This is used to displace the internal captive plug by up to 3mm, which will produce a pull out load in excess of 1.2KN in most concretes with consistent failure in base material.
Supported by UKAS testing of pull out test in accordance with BS 1881-207: 1992.

Promat manufactures to a quality system in accordance with ISO 9001:2000 and has received full accreditation to these standards.

Operating to these standards means that all activities, which have a bearing upon quality, are prescribed in written procedures. Systematic and thorough checks are made on all materials and their usage. Test equipment is subjected to regular checks and is routinely referred to national standards.

The information given in this data sheet is based on actual tests and is believed to be typical of the product. No guarantee of results is implied however, since conditions of use are beyond Promat control.

The use of eye protection and gloves is recommended. In addition, appropriate face masks should be used during any drilling operations.

Size and shape of the product would generally preclude ingestion. Medical attention should be sought in the event of parts being swallowed.

Normal hygiene precautions should be followed by washing hands before handling or eating food.

Promat activities are conducted with due regard to all statutory requirements with appropriate safeguards against exposing employees and the public to health and safety risks.